Digi-code 5012 manual

Control Transmitter Programming Instructions. These instructi ons apply to the following Digi-Code Garage Door Opener. Radio Cont rols: • Model / (MHz) / (MHz) Single Button Mini. Digi-Code manufactures access control devices for gate operator and garage door opener systems, as well as related products and accessories. "We felt there was a void of domestic-made products" says president Richard Caceres. "We believed, if we could manufacture quality products here in the USA that were reliable, fully compatible and. AND MODEL SINGLE BUTTON TRANSMITTERS are not expressly approved by Digi-Code Inc. could void the users authority to operate this equipment. This applies to intentional and intentional radiators certified per part 15 of the FCC rules and regulations. DIGI-CODE, INC.

DigiCode Remote. The Digi-Code Remote is a compatible replacement remote for the Stanley garage door opener remote. Features: Compatible with MHz frequency Digi-Code and Stanley receivers. 10 programmable DIP switches. Compatible with Stanley openers made between and Compatible with Digi-Code receiver models: Model - (mHz) or (mHz) Set both code switches to the code of your choice, being sure both are set the same since a different setting of just one switch will prevent operation. The digital code is determined by the position of the 10 small switches numbered 1 through 10 located in the receiver and the transmitter. Technical: The Digi-Code is a single button, MHz transmitter with 10 dipswitches that allows you to select one set of possible codes. Dimensions: 3 3/4" x 2 1/2" x 7/8". Compatibility: The Digi-Code is fully compatible with either Multi-Code digital radios or Stanley garage door openers (manufactured between and ).

This Digi Code / DC is a MHz garage or gate remote control that will control one Stanley or Digi Code MHz radio receiver. Unit is compatible with your existing Stanley , , MCS, or remote control. Programming is a snap just match the dip switches to your existing remote or receiver. MADE IN THE USA. Control Transmitter Programming Instructions. These instructi ons apply to the following Digi-Code Garage Door Opener. Radio Cont rols: • Model / (MHz) / (MHz) Single Button Mini. SETTING THE (“RECEIVER”) CODE SWITCH - TO WORK WITH MODEL AND MODEL SINGLE BUTTON TRANSMITTERS Use your finger to slide the “code switch hatch” from the receiver for access to the code switch. On the transmitter the entire front lower half of the case (“ the battery hatch”) is removeable.